Disassembly Instructions - Mitsubishi Electric MSZ-LN25VGW Service Manual

11

DISASSEMBLY INSTRUCTIONS

DISASSEMBLY INSTRUCTIONS
<"Terminal with locking mechanism" Detaching points>
The terminal which has the locking mechanism can be detached as shown below.
There are 2 types (Refer to (1) and (2)) of the terminal with locking mechanism.
The terminal without locking mechanism can be detached by pulling it out.
Check the shape of the terminal before detaching.
(1) Slide the sleeve and check if there is a locking lever or not.
Sleeve
Locking lever
MSZ-LN25VGW MSZ-LN35VGW MSZ-LN50VGW MSZ-LN60VGW
MSZ-LN25VGV MSZ-LN35VGV
MSZ-LN25VGB MSZ-LN35VGB
MSZ-LN25VGR MSZ-LN35VGR
OPERATING PROCEDURE
1. Removing the front panel and the panels (U/R/L/F)
Removing the front panel (Photos 1, 2)
(1) Hold the front panel and open it.
(2) Insert a screwdriver deeply into the holes to remove
the front panel.
Pry off the right and left arm holders by moving the
screwdriver down and towards the back wall (Photo
2-1).
(3) Remove the safety string from the center of the panel
(F).
NOTE: Hold the panel with your hand while detaching it
to avoid injury. (Figure 1)
Photo 2-2
Figure 1
(1)
OBH766
Slide the sleeve.
Pull the terminal while
pushing the locking
lever.
MSZ-LN50VGV
MSZ-LN50VGB
MSZ-LN50VGR
(1)
(2)
(3)
(2) The terminal with this connector has the
locking mechanism.
Hold the sleeve, and
pull out the terminal
slowly.
Connector
MSZ-LN60VGV
MSZ-LN60VGB
MSZ-LN60VGR
NOTE: Turn OFF the power supply before disassembly.
Photo 1
Outer vane (L)
(horizontal)
Screw of the left
side of the panel (U)
Panel (U)
Photo 2 Front panel stopper
Photo 2-1
(Enlarged view of the front panel stopper)
38
PHOTOS
Front panel
Outer vane (R)
(horizontal)
Screw of the right
side of the panel (U)
Catch
Safety string
Holes to remove
the front panel
Front panel stopper
Insert a screwdriver
into the hole, and
move it down and
towards the back
wall.