Low And High - Whirlpool ED22DW Use & Care Manual

Adjusting the crisper humidity cant
You can control the amount of humidity in the
moisture-sealed crisper.
1. The control can be adjusted to any setting
between LOW and HIGH.
2. LOW [open] lets moist air out of crisper for best
storage of fruits and vegetables with skins.
3. HIGH (closed) keeps moist air in the crisper for
best storage of fresh leafy vegetables.
Adjusting meat drawer temperature...
Tn
AlllUST
. .-._.. -
RATURE
--.....-m .- ^W.
T DRAWER TEMPEl
Cold air flows against the meat drawer through
an opening between the freezer and the refrigera-
tar. This helps keep the meat drawer colder than
the rest of the refrigerator.
Slide the control to let more or less cold air
Adjusting the refrigerator shelves...
T,, remOve glass S,.,&,eS:
SPILLGUARD shelves can be adjusted to match the
'i Remove items from shelf.
way you use your refrigerator. Glass shelves are
strong enough to hold bottles, milk and other
2. Slide shelf out with an even, constant pull
heavy food items.
to the stop.
q
II
il. Lift front and slide the rest of the way out.
To move shelf guides to new position:
r Lift front of guide. Pull guide forward off rear
support. Repeat for other guide.
k. To replace guide, push guide onto rear support.
Push front of guide down onto support.
GLASS SHELVES ARE
HEAVY. BE CAREFUL.
To replace glass shelves:
$. Guide rear of shelf into shelf guide.
2. Slide shelf into place.
Removing the crispers, meat draw
'e
:r and covers
To remove the crispers and meat drawer:
1. Slide crispers and meat drawer straight out to
the stop. Lift the front, then slide the rest of the
way out.
2. Replace in reverse order.
To remove the covers:
1. Lift front of cover off supports.
2. Lift out cover by pulling up and out,
PULL OUT TO THE S
LIFT THE FRONT
AND PULL AGAIN.
To replace the covers:
l
Fit back of cover in notch supports on walls of
refrigerator, then lower into place.
NOTE: Glass cover will fit only above full width
crisper.
LIFT THE COVER FRONT,
THEN THE BACK.