Programming The Speed Controllers - Conrad GAUI 500X-S Operating Instructions Manual

10. Programming the Speed Controllers

Page P.17
1. Call programming mode
Switch on the transmitter and move the throttle control lever to the full throttle position.
Connect the rechargeable battery to the speed controller. The motor connected to the controller emits 3 brief sounds with
increasing pitch and two brief separate sounds after two seconds.
After another 5 seconds, the connected motor emits 5 brief sounds with increasing pitch.
The controller is now in programming mode.
2. Call menu item
In programming mode, you will now hear 8 groups of different signals that are continually repeated in a loop. After the last
sound sequence (2 x long), the 5 brief sounds with increasing tone height will be audible again before the loop starts again.
Assignment of the respective signal sounds to the menu items can be taken from the following table.
No. Sound sequence
1 1 x brief
2 2 x brief
3 3 x brief
4 4 x brief
5 1 x long
6 1 x long, 1 x brief
7 1 x long, 2 x brief
8 2 x long
To call a specific menu item, slide the throttle control lever to the bottom-most position (motor off) within 2 seconds of the
respective sound signal.
The speed controller thus switches to setting mode for the menu item called.
3. Adjusting values
In the setting mode, you will now also hear different signals (see top line of the following table), which repeat in a
continuous loop. The point where the sequence starts again depends on the menu item called, since only those sounds are
emitted for which a value is stored as well.
After the sound signal for the desired value, slide the throttle control lever from the bottom-most position (motor off) to the
full throttle position at once.
4 sounds (high, low, high, low) are emitted as confirmation for the stored value.
The speed controller returns to the programming mode, where you can call and set the next menu item if required.
Braking
Battery type
Cut-off mode
Cut-off switching threshold
Start mode
Timing
38
Menu item or function
Braking
Battery type
Cut-off mode
Cut-off switching threshold
Start mode
Timing
Call default settings
Exit programming mode
1 x brief 2 x brief
Off On
Lithium NiMH/NiCd
turn down switch off
low medium
normal soft
low medium
3 x brief
high
very soft
high