Mechanics Setup - Conrad GAUI 500X-S Operating Instructions Manual

8. Mechanics Setup

Take the manufacturer's manual with the assembly sketches and start assembly of your quadrocopter according to the
drawings starting on page P.1.
Page P.1
Upper figure:
Take the floor plate of the central frame and screw the four inner boom holders with the rotary bearings on according to the
figure. Comply with the manufacturer's drawing precisely. The pins for the boom tube latch must be at the bottom near the
floor plate.
Important!
Tighten the screws (Ø 3 x 8) only until the boom holders can still be rotated around the bearing points.
Lower figure:
Put the cover plate of the central frame onto the rotating bearings of the four boom holders and screw the plate on with four
screws (Ø 3 x 8). It still must be possible to turn the boom holders around their bearing points.
Put the 6 spacer bolts (2 x 3.5 x 22 mm) between the two frame plates and screw the plates on with twelve screws M2 x 5.
Use low-strength threadlocker varnish for the screw connection.
Page P.2
Upper figure:
Push the four outer boom holders between the frame plates according to the figure and attach the boom holders with four
screws from the top (Ø 3 x 8).
Important!
Insert the boom holders so that the larger hole for the clamping screw head is aligned upwards (see upper figure,
page P.7).
Lower figure:
The four lower screws (Ø 3 x 8) are installed with one spacer ring (3 x 4 x 1 mm) each. Then insert the four dampening
rubbers for the GYRO carrier plate.
Page P.3
Upper figure:
Insert the landing leg spring into one of the two motor gondola halves and screw the gondola halves together according to
the figure. Do not tighten the screws firmly yet.
Lower figure:
Insert the motor in the motor gondola according to the figure and screw it on slightly with four screws
(M3 x 4). Use medium-strength threadlocker varnish and do not tighten the screws firmly yet.
30