Table of Contents
Advertisement
5.1 Configuring Parameters
Purpose:
By configuring the parameters you can define the parameters which affect the image quality, such as the
transmission stream type, the resolution and so on.
Before you start:
1. Make sure that the HDD has already been installed. If not, please install a HDD and initialize it.
(Menu>HDD>General)
2. Check the storage mode of the HDD.
1)
Click Advanced to check the storage mode of the HDD.
2)
If the HDD mode is Quota, please set the maximum record capacity For detailed information, see
Chapter Configuring Quota Mode.
3)
If the HDD mode is Group, you should set the HDD group. For detailed information, see Chapter
4)
Configuring HDD Group for Recording.
Steps:
1.
Enter the Record settings interface to configure the recording parameters:
Menu>Record>Parameters
Figure 5. 1 HDD- General
Figure 5. 2 HDD- Advanced
42
Advertisement
Table of Contents
