Table of Contents
Advertisement
10.1 Initializing HDDs
Purpose:
A newly installed hard disk drive (HDD) must be initialized before it can be used with your NVR.
Steps:
1. Enter the HDD Information interface.
Menu > HDD> General
2. Select HDD to be initialized.
3. Click the Init button.
4. Select the OK button to start initialization.
5.
After the HDD has been initialized, the status of the HDD will change from Uninitialized to Normal.
Initializing the HDD will erase all data on it.
Figure 10. 1 HDD Information Interface
Figure 10. 2 Confirm Initialization
Figure 10. 3 HDD Status Changes to Normal
128
Advertisement
Table of Contents
