Philips FC6161 User Manual page 9

, The charging light goes on to indicate that the appliance is charging.
Note: The charging light does not give any information about the battery
charge level of the vacuum cleaner.
When the appliance is fully charged, the charging light goes out.
,
Note: You can leave the appliance on the charging base, even when it is fully
charged. Every 5 minutes, the charging light lights up for 3 seconds. This
indicates that the appliance is checking if the batteries are still fully charged.
Note: If you put the appliance on the charging base while it is switched on, the
appliance switches off automatically after 2 seconds.
saving energy
If you are not going to use the appliance for a longer period of time,
remove the adapter from the wall socket to save energy.
using the appliance
using the stick unit
You can use the stick unit to clean floors and carpets.
When you use the stick unit, always make sure the dust compartment
is attached to the handheld vacuum cleaner, to prevent damage to the
handheld vacuum cleaner.
1 Place the handheld vacuum cleaner properly in the stick unit ('click').
2 Press the on/off button to switch on the appliance.
The appliance starts to operate at normal speed. Use this speed for
,
optimal operating time and minimal noise. The operating time at this
speed is more than 20 minutes.
- Press the MAX button if you want to operate the appliance at
maximum speed. Use this speed for optimal cleaning performance. The
operating time at this speed is 11 minutes.
- If you want to switch back to normal speed, press the MAX button
again.
Note: During use, the 'brush blocked' light may flash red to indicate that the
roller brush is blocked. If this happens, you have to remove the item that is
blocking the brush or clean the brush (see chapter 'Cleaning').
English
9