Accessories - iRobot ROOMBA 800 SERIES Owner's Manual

• If Roomba encounters an area of high debris concentration, it
will move in a spiral motion to clean the area more thoroughly
EN
When Roomba does this, you will see the CLEAN button pulse.
• To use SPOT Cleaning, place Roomba on top of the localized debris
and press (SPOT) on the robot. Roomba will intensely clean the
areaby spiraling outward about 3 feet (1meter) in diameter and
then spiraling inward to where it started.
Note: After each use, empty the bin and clean the filter.
• Always store Roomba on the Home Base so it's charged and ready
to clean when you need it. If storing off of the Home Base, remove
the battery first and then store Roomba and the battery in a cool,
dry place.
Battery and Charging
• Charge Roomba using the Home Base. Indicator lights will turn
off after 60 seconds to conserve energy while Roomba is charging.
Check status of the battery by pressing the CLEAN button to
illuminate the Battery Indicator. Indicator will appear amber while
the battery is charging and solid green when fully charged.
4 For more information, visit www.irobot.com/Roomba800

Accessories

The Dual Mode Virtual Wall Barrier
(accessory compatible with all models)
The Dual Mode Virtual Wall barrier keeps
Roomba in the places you want to be
cleaned — and out of the ones you don't.
In between cleaning cycles, you can leave
the device operating in its position on the
floor. You can set your device to one of two
modes to fit your home's cleaning needs:
Note: Under normal use, batteries will last 8-10 months. If you are not
planning on using your Virtual Wall device for an extended period of time
and you would like to store it, be sure to switch it to the "Off " (middle) position.
Virtual Wall Mode: When the switch is
in the "up" position ( ), the device
functions as a Virtual Wall. This means
that you can set it to block openings of
up to 10 feet (3 meters). It creates an
invisible, cone-shaped barrier that only
Roomba can see.
Note: This barrier gets wider as it gets
further from the device (refer to illustration).
Halo Mode: When the switch is in the
"down" position ( ), the device creates
a protective zone that Roomba will
not enter. This prevents Roomba from
bumping into items you want to protect
(e.g. a dog bowl or vase) or crossing into
undesired areas (e.g. a corner or under
a desk). The Halo is invisible and reaches
approximately 24 inches (60 centimeters)
from the center of the device.