Troubleshooting - Ryobi RPW36X50 Original Instructions Manual

TROUBLESHOOTING

Problem Possible causes
Machine does not start Drained battery
Deffective battery
Fuse has blown
Fluctuating pressure Pump is sucking air
Valves are dirty, worn out, or stuck
Pump seals worn out
Motor busses Low voltage or low temperature
Machine stops Fuse has blown
Drained battery
Thermal sensor activated
Nozzle partially blocked
Fuse blows Fuse too small
Machine pulsating Air in inlet hose/pump
Inadequate supply of mains water
Nozzle partially blocked
Water filter blocked
Hose kinked
Machine often starts Pump/spray handle is leaking
and stops by itself
Machine starts, but no Pump, hoses, or other accessory is
water comes out frozen
No water supply
Water filter blocked
Nozzle blocked
Solution
Charge the battery.
Replace with compatible battery pack.
Bring the product to an authorized service centre for service or repair.
Check that hoses and connections are air tight.
Clean and replace the part or refer to a local distributor.
Clean and replace the part or refer to a local distributor.
Activate the trigger of the spay handle.
Bring the product to an authorized service centre for service or repair.
Charge the battery.
Leave the pressure washer for 15 minutes to cool down.
Clean the nozzle.
Bring the product to an authorized service centre for replacement.
Allow the product to run with open trigger until regular working
pressure resumes.
Check that the water supply corresponds to the specifications required
(see model tag). Avoid using long, thin hoses.
Clean the nozzle.
Clean the filter.
Straighten out hose.
Contact your nearest authorized service centre.
Wait for the pump, hoses, or other accessory to thaw.
Connect the water inlet port to a power supply.
Clean the filter.
Clean the nozzle.
21