Chapter 2 Switch Installation; Preparing - Cisco Catalyst 2360 Hardware Installation Manual

Preparing

Do not stack the chassis on any other equipment. If the chassis falls, it can cause severe bodily injury
Warning
and equipment damage. Statement 48
Ethernet cables must be shielded when used in a central office environment. Statement 171
Warning
Warning Do not work on the system or connect or disconnect cables during periods of lightning activity.
Statement 1001
Warning Read the installation instructions before connecting the system to the power source. Statement 1004
Warning This unit is intended for installation in restricted access areas. A restricted access area can be
accessed only through the use of a special tool, lock and key, or other means of security.
Statement 1017
The plug-socket combination must be accessible at all times, because it serves as the main
Warning
disconnecting device.Statement 1019
This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the
Warning
absence of a suitably installed ground conductor. Contact the appropriate electrical inspection
authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024
This unit might have more than one power supply connection. All connections must be removed to
Warning
de-energize the unit. Statement 1028
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning For connections outside the building where the equipment is installed, the following ports must be
connected through an approved network termination unit with integral circuit protection: 10/100/1000
Ethernet. Statement 1044
Catalyst 2360 Switch Hardware Installation Guide
2-2
Chapter 2 Switch Installation
OL-22150-02