Lcd Module - Sony FWD-40LX1 Service Manual

1-5-3. LCD Module

m
. When replacing the LCD module, be sure to work with two persons.
. After replacing the LCD module, be sure to perform the "2-2-6. White Balance Adjustment".
Removal
1. Remove the cabinet assembly.
(Refer to Section 1-3-1.)
2. Remove the bezel assembly. (Refer to Section 1-3-2.)
3. Remove the two arms, shield cover D and shield cover
G assembly. (Refer to steps 2 to 4 of Section 1-4.)
4. Disconnect the five connectors from the DC fans (left,
center and right). (Refer to Section 1-5-1.)
5. Remove the control button panel.
(Refer to step 2 of Section 1-4-6.)
BVST
3 x 6
Cushion
LVDS cable
Installation
11. Reattach the LCD module in the reverse order of steps 6 to 10.
12. Reassemble this unit in the reverse order of steps 1 to 5.
1-14
G base chassis assembly
BVST
3 x 6
PSW
M3 x 8
6. Remove the four screws (BVST3 x 6), then remove
the D base chassis assembly.
7. Remove the eight screws (BVST3 x 6), then remove
the G base chassis assembly.
8. Remove the cushion and screw (PSW M3 x 8), then
remove the LVDS cable.
9. Disconnect the two harnesses from the LCD module.
10. Remove the eight screws (PSW5 x 8), then remove the
LCD bracket assembly.
D base chassis assembly
BVST
3 x 6
PSW
5 x 8
LCD bracket
assembly
Harnesses
LCD module
Conductive cushion
FWD-40LX1