Teletext Mode; Child Lock - Tevion UR4200 Instruction Manual

8. Press the OK button (22). The result will be displayed.
9. Quit the process by pressing any source device
selection button (2).

Teletext Mode

Use the TTX/MIX button (31) to switch to Teletext mode.
Press the TTX/MIX button (31) again to exit Teletext mode.
Depending on the device that you use for Teletext
reception, the mixed mode will appear first. In this
case you must press the TTX/MIX button (31)
a third time to switch Teletext off.
The following buttons are available for Teletext control:
(3) Direct input of the Teletext page via numeric buttons
(24) Toggle to the next Teletext page
(25) Toggle to the previous Teletext page
(5) Stop page scan
(6) Mix Teletext and TV picture
(20) Disable Teletext

Child lock

The child lock function lets you block the numeric keypad
(3) and the buttons CH+ (24) and CH- (25). This will avoid
channels being switched. The child lock can be enabled and
disabled for each source device selection button individually.
Proceed as follows to enable or disable child lock:
1. Press and hold the SET button (21) for at least 3 seconds.
The display shows [CODE SETUP]. Then release the SET
button (21).
2. Press (8). The display shows [CONFIGURE].
3. Press the OK button (22). The display shows
[TIME SETUP].
4. Press (8) twice. The display shows [KIDS LOCK].
5. Press the OK button (22). The display shows [TV OFF].
6. Press the source device selection button for which you
want to enable or disable the child lock function.
7. Press or
enabled) or [OFF] (child lock disabled).
8. Press the OK button (22). The message [SUCCESS] will
appear for a few seconds and the device returns to the
[KIDS LOCK] level.
9. Quit the process by pressing the EXIT button (23) twice.
After Sales Support
(8) to toggle between [ON] (child lock
TEL: 1300 663 907
24