Erasing All Learned Key Codes - Tevion UR4200 Instruction Manual

5. Press (8) twice. The display shows [DELETE DEV].
6. Press the OK button (22). The display shows [SELECT DEV].
7. Press the source device selection button (2) of the device
for which you want to erase all programmed information.
The display shows [SURE DELET].
8. Press the OK button (22) to confirm the deletion.
If there is a large number of assigned key codes, the
deletion may take some time. During this process,
the display will show [WAITING].
9. The message [DELETED] will appear for a few seconds
and the device returns to the previous menu
[SELECT DEV].
10. Quit the process by pressing the EXIT button (23)
three times.

Erasing All Learned Key Codes

This function allows you to erase all manually learned key
commands for all devices. Any buttons that have been
programmed via a device code will not be erased.
1. Press and hold the SET button (21) for at least 3 seconds.
The display shows [CODE SETUP]. Then release the
SET button (21).
2. Press (8) twice. The display shows [LEARNING].
3. Press the OK button (22). The display shows [LEARN KEY].
4. Press (8) three times. The display shows [DELETE ALL].
5. Press the OK button (22). The display shows
[SURE DELET].
6. Press the OK button (22) to confirm the deletion.
If there is a large number of assigned key codes, the
deletion may take some time. During this process,
the display will show [WAITING].
7. The message [DELETED] will appear for a few seconds and
the device returns to the previous menu [DELETE ALL].
8. Quit the process by pressing the EXIT button (23) twice.
After Sales Support TEL: 1300 663 907
15