Macros; Programming A Macro - Tevion UR4200 Instruction Manual

Macros

Macros allow you to execute up to 16 button commands
in sequence by just pressing one single button. The used
buttons may correspond to multiple devices.
For instance, press just one single button to perform
the following sequence of operations:
• Power-up the TV set
• Switch the TV set to the DVD player input source
• Power on the DVD player
• Start DVD playback

Programming a Macro

1. Press and hold the SET button (21) for at least 3 seconds.
The display shows [CODE SETUP]. Then release the SET
button (21).
2. Press (8) three times. The display shows [MACRO].
3. Press the OK button (22). The display shows [MACRO1].
If necessary, press the
another sequential macro number to save your
macro. You can use the presets Macro1 to Macro6
for saving.
4. Press the OK button (22). The display shows [SET UP].
If you have chosen a preset and there is already
a macro stored under this position, the message
[MACRO HAS] will be displayed.
5. Press the OK button (22). The last selected device type
will show on the display.
6. First enter the source selection button of the device that
you want to execute the first command. To do this, press
the corresponding source selection button (2).
7. Press one or more buttons in sequence whose functions
shall be executed. You can execute up to 16 commands
in the same macro.
If you want to execute a function for a different
device, first press the corresponding source device
selection button (2). Switching the device will
diminish the number within the 16 programmable
commands.
8. After all the desired buttons have been programmed,
press the OK button (22). The message [SUCCESS] will
appear for a few seconds and the device returns to the
previous menu.
9. Quit the process by pressing the EXIT button (23)
two times.
After Sales Support
or (8) button to select
TEL: 1300 663 907
16