Entering Device Codes Directly - Tevion UR4200 Instruction Manual

Entering Device Codes Directly

Switch on the device for which you want to program the
remote control. If your device is a VCR or a CD or DVD player,
please insert a tape or CD/DVD.
To cancel the following programming at any time,
press EXIT (23) to return without saving any changes.
Press the EXIT button (23) multiple times until the
remote control has returned to standard mode.
1. Search for the first available code by using the device
type and manufacturer (see the code book).
2. Point the remote control to the TV set while entering
the commands.
3. Press the source device selection button of the device
you want to program. In this example, it is the TV button
(2). The display shows [TV].
4. Press and hold the SET button (21) for at least 3 seconds.
The display shows [CODE SETUP]. Then release the
SET button (21).
5. Press the OK button (22). The display shows
[BRAND SRCH].
6. Press V (8) twice. The display shows [CODE SET].
7. Press the OK button (22). The message [TV] will blink
on the display. The current device code is the 4-digit
code below it.
8. Press the OK button (22) again. The first digit of the
current device code starts blinking.
9. Enter the four digits of the device code that you have
found on the list. To do this, press the numeric keys (3).
After you have entered the information, the first digit
will blink again. If you mistyped the code, you have
the chance to enter it again at this time.
Only for the device type AUX, a fifth digit must be
entered to set the device code. To do this, use the
following list.
0–TV
1–VCR
2–DVD
3–STB
4–DVR
5–AUDIO
6–Cable
7–CD
After Sales Support TEL: 1300 663 907
10