Radio; Manual Tuning - Panasonic SC-AKX38 Operating Instructions Manual

RQT9895-M_en.fm Page 12 Monday, November 25, 2013 5:51 PM

Radio

Preparation
Press [RADIO/EXT-IN] to select "FM" or "AM".

Manual tuning

1
Press [RADIO/EXT-IN] to select "FM" or "AM".
2
Press [3] or [5] to tune in to the station.
To tune automatically, press and hold the button until
the frequency starts changing quickly.
" " is shown when a stereo broadcast is being
received.
Using the main unit
1
Press [TUNE MODE] to select "MANUAL".
2
Press [2/3] or [5/6] to tune in to the
station.
Improving the sound quality
When "FM" is selected
1
Press [PLAY MENU] to select "FM MODE".
2
Press [Y, U] to select "MONO" and then press [OK].
To cancel, select "STEREO".
"MONO" is also canceled when you change the
frequency.
When "AM" is selected
1
Press [PLAY MENU] to select "B.PROOF".
2
Press [R, T] to select "BP 1" or "BP 2" and then
press [OK].
To memorize the setting
Continue with step 4 of "Manual presetting".
Memory presetting
You can preset up to 30 FM and 15 AM stations.
█
Automatic presetting
1
Press [OK] to select "LOWEST" or "CURRENT"
frequency.
LOWEST Tuning begins from the lowest
frequency.
CURRENT Tuning begins from the current
frequency.
2
Press [PLAY MENU] to select "A.PRESET" and then
press [OK].
"START?" is shown.
3
Press [OK] to start presetting.
To cancel, press [8].
12
Confidential
Until: 28 Jan 2014
Safety application draft
█
Manual presetting
1
Press [3] or [5] to tune in to the station.
2
Press [PROGRAM].
3
Press the alphanumeric buttons to select a preset
number.
Do steps 1 through 3 again to preset more stations.
The new station replaces any station that occupies
the same preset number.
█
Selecting a preset station
Press the alphanumeric buttons, [2] or [6] to
select the preset station.
Using the main unit
1
Press [TUNE MODE] to select "PRESET".
2
Press [2/3] or [5/6] to select the preset
station.
Checking the signal status
When "FM" is selected
Press [DISPLAY].
FM The FM signal is in monaural.
The system is not tuned in to a station.
FM ST The FM signal is in stereo.
FM MONO "MONO" is selected as the
"FM MODE".
AM/FM allocation setting
By main unit only
For South America
This system can also receive AM broadcasts allocated in
10 kHz steps.
For Central America and the Caribbean
This system can also receive FM broadcasts allocated in
0.2 MHz steps.
1
Press [RADIO/EXT-IN] to select "FM" or "AM".
2
Press and hold [RADIO/EXT-IN].
After a few seconds, the display panel shows the current
minimum radio frequency. Release the button when the
minimum frequency changes.
• To go back to the initial setting, do the above steps
again.
• Preset frequencies are erased after you change the
setting.