Jeep KJ 2005 Service Manual page 186

KJ
BRAKES - ABS
DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . 41
OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . 41
DIAGNOSIS AND TESTING - ANTILOCK
BRAKING SYSTEM
STANDARD PROCEDURE - ABS BRAKE
BLEEDING . . . . . . . . . . . . . . . . . . . . . . . . . . . 42
SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . 42
ELECTRICAL
DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . 43
OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . 43
FRONT WHEEL SPEED SENSOR
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 43
BRAKES - ABS
DESCRIPTION
ANTILOCK BRAKING SYSTEM
The purpose of the antilock system is to prevent
wheel lockup during periods of high wheel slip. Pre-
venting lockup helps maintain vehicle braking action
and steering control.
The antilock ABM activates the system whenever
sensor signals indicate periods of high wheel slip.
High wheel slip can be described as the point where
wheel rotation begins approaching 20 to 30 percent of
actual vehicle speed during braking. Periods of high
wheel slip occur when brake stops involve high pedal
pressure and rate of vehicle deceleration.
Battery voltage is supplied to the ABM ignition ter-
minal when the ignition switch is turned to Run posi-
tion. The ABM performs a system initialization
procedure at this point. Initialization consists of a
static and dynamic self check of system electrical
components.
The static check occurs after the ignition switch is
turned to Run position. The dynamic check occurs
when vehicle road speed reaches approximately 30
kph (18 mph). During the dynamic check, the ABM
briefly cycles the pump and solenoids to verify oper-
ation.
If an ABS component exhibits a fault during ini-
tialization, the ABM illuminates the amber warning
light and registers a fault code in the microprocessor
memory.
BRAKES - ABS
TABLE OF CONTENTS
. . . . . . . . . . . . . . . . . . . . 42
page
INSTALLATION
REAR WHEEL SPEED SENSOR
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 44
INSTALLATION
HCU (HYDRAULIC CONTROL UNIT)
DESCRIPTION
OPERATION
REMOVAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 45
DISASSEMBLY
ASSEMBLY
INSTALLATION
ELECTRONIC BRAKE DISTRIBUTION
The electronic brake distribution (EBD) functions
like a rear proportioning valve. The EBD system uses
the ABS system to control the slip of the rear wheels
in partial braking range. The braking force of the
rear wheels is controlled electronically by using the
inlet and outlet valves located in the HCU.
OPERATION
ANTILOCK BRAKING SYSTEM
During normal braking, the master cylinder, power
booster and wheel brake units all function as they
would in a vehicle without ABS. The HCU compo-
nents are not activated.
During antilock braking fluid pressure is modu-
lated according to wheel speed, degree of slip and
rate of deceleration. A sensor at each wheel converts
wheel speed into electrical signals. These signals are
transmitted to the CAB for processing and determi-
nation of wheel slip and deceleration rate.
The ABS system has three fluid pressure control
channels. The front brakes are controlled separately
and the rear brakes in tandem. A speed sensor input
signal indicating a high slip condition activates the
CAB antilock program. Two solenoid valves are used
in each antilock control channel. The valves are all
located within the HCU valve body and work in pairs
to either increase, hold, or decrease apply pressure as
needed in the individual control channels. The sole-
noid valves are not static during antilock braking.
They are cycled continuously to modulate pressure.
Solenoid cycle time in antilock mode can be mea-
sured in milliseconds.
BRAKES - ABS
. . . . . . . . . . . . . . . . . . . . . . . . . 43
. . . . . . . . . . . . . . . . . . . . . . . . . 44
. . . . . . . . . . . . . . . . . . . . . . . . . 44
. . . . . . . . . . . . . . . . . . . . . . . . . . . 44
. . . . . . . . . . . . . . . . . . . . . . . . . 45
. . . . . . . . . . . . . . . . . . . . . . . . . . . . 46
. . . . . . . . . . . . . . . . . . . . . . . . . 47
5 - 41
page