Boiler Maintenance; Special Maintenance; How To Use The Accessories; Large Brush With Steam/Vacuum Function - Kruger KGV3000D Instruction Manual

- Aspirate about half liter clean water to rinse theducts.
- Perform it twice
To sterilize it altogether, briefl y steam the cover (15) (Fig. 1) and the tank (25) (Fig. 5) including its
components and all extension hoses and accessories whichmay have been used.
- Rinse and replace on the appliance.
- Rewind the power supply cable (13) (Fig. 1) on the appropriate cable winder (12) (Fig. 2).
-As has already been stated in the Safety warnings, NOR PERFUMES OR OTHER SUBSTANCES
SHOULD BE POURED IN THE BOILER'S WATER TANK, AND ONLY DRINK WATER AND NEVER
DISTILLED WATER SHOULD BE USED.
12. BOILER'S MAINTENANCE
(Before performing any maintenance operation, unplug the appliance from the electrical outlet).
In order to minimize the negative effects of limes calein water, the boiler should be fully drained every
2/3 months. Act as follows:
1 – make sure that the appliance has cooled down
2 – using a coin, unscrew the plastic cap covering thedraining nut (Fig. 13A)
3 – using the enclosed box spanner (36) (Fig. 6), unscrew the draining nut (Fig. 13B-C)
4 – carefully shake the appliance and allow the waterand the limescale in the boiler to run out
5 – screw the draining nut and the plastic cap back on

13. SPECIAL MAINTENANCE

- Always contact the nearest Service Centre or the manufacturer, in case of failure and/or malfunction.
Any unauthorized alteration will void the warranty and may cause danger.
- Never open the device.
- Never try to dismantle the device. Always refer to the Service Centre or the Main Offi ce.
- Always make sure that the plug and cable are not damaged. In case they need to be replaced,
contact the nearest Service Centre.

14. HOW TO USE THE ACCESSORIES

The accessories are to be carefully pushed into place, and fastened by rotating the locking ring.
14.1 CONTROL HANDLE
The control handle can be used as steam gun, by setting the steam release pressure on it. All
accessories can be connected to the steam gun.
14.2 LARGE BRUSH WITH STEAM - VACUUM FUNCTION
The large brush (32) (Fig. 6) can be used for both steam cleaning and vacuuming.
14.3 SMALL BRUSH WITH STEAM VACUUM FUNCTION
The small brush (33) (Fig. 6) is suitable both for steam cleaning and for the vacuuming of areas which
would be diffi cult to reach with the large brush. For the steam function, it's advisable to fi t the frame
(33b) (Fig. 6) (double profi le rubber frame – wash&dry function). The frame (33a) (Fig. 6) (double
profi le bristled frame) is suitable for dry vacuuming or steam cleaning, with the aid of the sponge with
elasticized cover, if necessary (34) (Fig. 6).
kruger.es 27