PPPoE Passthrough
To access the "
PPPoE Passthrough
"Utilities" screen. The Gateway allows passthrough of up to
the
channels in this screen. Actiontec recommends not changing these values
PVC
without consulting the
Restore Default Settings
To restore the Gateway to its factory default settings, select Restore Default Settings
from the "Utilities" screen. When the "Restore Default Settings" screen appears, click
Restore Default Settings. Any changes made to the Gateway's settings will be lost
and the factory default settings will be restored. During this process, the Gateway's
Power light flashes and the Gateway is disabled.
N
Warning: Do not unplug the power cord from the Gateway, or
turn off the Gateway using the Power switch, during the Restore
Default Settings process. Doing so may result in permanent
damage to the Gateway.
When the Power light stops flashing and glows steadily green, the Gateway is fully
operational, and the default settings have been restored.
Chapter 6 Using Utilities
" screen, select
.
ISP
59
PPPoE Passthrough
8 PVC
from the
channels. Set up