ActionTec GT704WGRV Quick Start Manual

1
Connect the Gateway to a Computer
Step 4 Plug the larger end of
the Power Cord into a Power
Step 1 Get the Wireless DSL
Outlet.
Gateway from your DSL
Quick Start Kit.
Wireless DSL Gateway
Step 5 Make sure the Power
Switch is ON.
Step 2 Get the Power Cord
from your DSL Quick Start Kit.
Step 6 Confirm the Power
Light on the Gateway is SOLID
Power Cord
Green.
Note: The DSL light may blink.
Step 3 Plug the smaller end
Black Port
of the Power Cord into the
Black Port on the back of the
Gateway. Step 7 Get the Yellow
Power
Step 8 Plug one end of the
Cord
Yellow Cable into one of the
Yellow Ports on the back of
the Wireless DSL Gateway.
Step 9 Make sure that your
Power
Outlet computer is turned on. Then,
Power
plug the other end of the Yellow
Cord
Cable in the Ethernet Port on
the back of the computer.
An Ethernet Port looks similar
to a regular Phone Jack, but is
slightly larger.
Step 10 Confirm that 1 of the
Power Switch
4 Ethernet lights on the
Gateway is Green. This may
take a few moments.
Power Light on Wireless DSL Gateway Note: If the Ethernet Light does NOT turn green, make sure the Yellow Cable is
properly connected on both ends.
Step 11 Get the Black or Gray
Cable.
DSL Cable from your DSL
Quick Start Kit.
Yellow Port
Step 12 Plug one end of the
DSL Cable into the Gray Port
on the back of the Gateway.
Yellow Cable
Step 13 Plug the other end of
Phone
Port
the DSL Cable into the Phone
Jack closest to your computer.
Step 14 Confirm that the
Power and DSL Lights are
solid Green. This may take up
to 30 seconds.
Power & DSL Lights on Wireless DSL Gateway
Ethernet Lights on Wireless DSL Gateway
Note: If the DSL Light continues to blink, make sure you received notification from
your DSL Internet Service Provider that your DSL service is On.
White Port
Black Cable
2
Install the Phone Filters
What are Phone Filters? Phone Filters separate the DSL signal
Black from the voice signal, allowing you to talk on the telephone
Cable
and be online at the same time.
All Devices with the same phone number as your DSL Line
require Phone Filters. This includes telephones, fax machines,
caller ID boxes, satellite TV receivers and answering machines.
Step 1 Unplug your Telephones
(or other devices) from their
current Phone Jacks.
Step 2 Open the Clear Bag
and remove the Phone Filters
from the bag.
Note: The number and type of Phone Filters included in this kit may vary.
Step 3 Plug a Phone Filter into
Phone
every Phone Jack in your house Jack
with the same phone number
as your DSL Line, and a
telephone (or other device)
Phone
connected to it.
Filter
If you need additional Phone
Filters, contact your DSL Internet
Service Provider.
Step 4 Plug one end of the
Phone
Phone
Phone Cord into the Phone Jack
Filter and keep the other end
attached to the telephone (or
other device).
Phone Phone
Cord Filter
Step 5 Make sure you did
NOT put a Phone Filter on the
Black DSL Cable. Make sure
your setup looks EXACTLY like
DSL
Yellow Cable Power
the picture to the right.
Cable Cord
Flip this Quick Start Guide over to continue