Installing The Ribbon - Epson TM-U295 Installation Manual

2. Unplug the power plug of the power supply from the outlet.
3. Hold the connector of the DC cable and unplug it from the
printer's connector.

Installing the Ribbon

Be sure to use the EPSON ERC-27, the ribbon cassette that meets
the printer's specifications.
1. Turn on the printer.
2. Press the RELEASE button to turn on the LED. This puts the
printer in the paper release mode.
3. Turn off the printer.
CAUTION:
4. Be sure to perform the steps above because it is necessary to
make sure that the printer is in the paper release mode before
you install the ribbon cassette.
5. Open the printer cover by slightly pressing the ridges on the
top left and pulling the cover forward, as shown in the
illustration below.
6. Check that the ribbon in the cassette is not creased or twisted.
Then turn the feed knob in the direction of the arrow on the
ribbon cassette to take up any slack in the ribbon.
7. Carefully insert the ribbon cassette in the printer as shown in
the illustration below. Notice exactly where the ribbon must go.
TM-U295 Installation Manual 9
English