Operation - Craftsman 5335 Operator's Manual

NOTICE: The battery pack will fully charge, but will not overcharge, if left on the charger.
NOTICE: Charger may warm
with several continuous charge
cycles. This is part of the normal
operation of the charger. Charge
in a well ventilated area.
WALL-MOUNT HOLES (Fig. 3)
The charger has hanging holes for
convenient storage. Install screws
(available separately) in the wall 3
inches apart.
Use screws sufficiently strong to
hold the combined weight of the charger and battery pack.
ѥ
WARNING: Always wear safety goggles or safety glasses with side shields
when using compressed air to clean the tool. If the operation is dusty, also wear a
dust mask.
GENERAL MAINTENANCE
Avoid using solvents when cleaning plastic parts. Most plastics are susceptible
to damage from various types of commercial solvents and may be damaged by
their use. Use clean cloths to remove dirt, dust, oil, grease, etc.
ѥ
WARNING: Do not at any time allow brake fluids, gasoline, petroleum-based
products, penetrating oils, etc. to come in contact with plastic parts. Chemicals can
damage, weaken or destroy plastic which may result in serious personal injury.
ѥ
WARNING: When servicing, use only identical Craftsman replacement parts. Use
of any other parts may create a hazard or cause product damage. To ensure safety
and reliability, all repairs should be performed by a qualified service technician.
Fig. 3
MAINTENANCE
10
Wall-mount holes