Controlling The Sb-218 Subwoofer - P.Audio SB218 User Manual

For linking between amplifiers, standard CAT5 type cabling can be used.
To connect the COM cable to the VIA series amplifiers, simply connect the USB plug to the windows
computer, and plug the other end into the socket on any available VIA series amplifier. Ensure to
align the plug correctly and do not exert too much force onto the USB plug.
ID
Once the required amplifiers are all linked together,
the software can be started. To start the software,
click start All Programs  VIA-SUB  VIA-SUB
Application.
Once the COM cable is chosen, the software needs to
know which units to communicate with. ID for VIA
series amplifiers as set by the factory range from 1-
32, although the user to is free to change this as they
see fit with the 'configure ID Device' utility. The
software can communicate with a maximum of 32
units at once.
Once all is set up, press OK and the software will
launch.

CONTROLLING THE SB-218 SUBWOOFER

Once the software is up and running, all connected speakers will be seen in the ID list to the left
hand side of the screen. All parameters available to the user will be available by double clicking the
device required to monitor, and the parameters screen will be displayed.
Across the top of the parameters window, there are several options available to the user:
Load – Allows loading of a preset file from a storage location such as the computer hard drive.
Page | 8