Audio Connection - P.Audio SB218 User Manual

To mate the AC mains cable with the AC mains connector on the amplifier, align the plug with the
connector, insert the plug, and rotate clockwise until a 'click' is heard and the cable is locked into
place. This locking mechanism also functions as the power switch for the amplifier.
To disconnect the cable end of the AC mains connector, pull back on the yellow thumb grip, and
rotate the plug assembly counter-clockwise until the connector can slide out easily.
TIP: Always connect the cable before turning on mains power to avoid accidents.
Likewise, also turn off mains power before disconnecting the cable. NEVER carry a
live cable to the speaker before connection.
NOTE: DO NOT CONNECT THE AC MAINS END OF THE AC MAINS CABLE IN AN AREA
THAT IS WET OR SUBJECT TO CONDENSATION OR DAMP CONDITIONS!
Once the AC mains cable is securely connected to both the amplifier and AC mains supply, the
amplifier will be turned on. It is good practice to lower the volume level during turn on to avoid any
unexpected loud audio. As such it is also recommended to connect signal cables before powering up
the system.
NOTE: If the pilot light does not illuminate within 30 seconds the unit may have a
fault. If this occurs, the unit should be returned to P.Audio for evaluation.
THERE ARE NO USER-SERVICABLE PARTS INSIDE. DO NOT REMOVE THE AMPLIFIER MODULE! (See
the section below "Replacement of Components" for more detailed information).

4.2. Audio Connection

Page | 5