Before First Use - IKEA VÄLGJORD Manual

ENGLISH
It is possible to deactivate the rinse aid
dispenser only if the option Multitab is
activated, in this case the dispenser will not
release rinse aid.
If the dispenser is deactivated and Multitab
option is not selected, the dispenser will still
release rinse aid according to the level set
(see "How to set the rinse aid level").
The use of the option Multitab with the rinse
aid dispenser deactivated may not give
satisfying drying results.
When the rinse aid dispenser is
deactivated, the rinse aid indicator is
always off when the option Multitab is
activated.
How to deactivate the rinse aid dispenser
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously
the indicators
start to flash and the display is blank.
2. Press .
• The indicators
off.
• The indicator
flash.
• The display shows the current setting:
= the rinse aid dispenser is
activated (factory setting).
3. Press to change the setting.

Before first use

1. Make sure that the current level of the
water softener agrees with the
hardness of the water supply. If not,
adjust the level of the water softener.
2. Fill the salt container.
3. Fill the rinse aid dispenser.
and until
, , and
, and
continues to
= the rinse aid dispenser is
deactivated.
4. Press the on/off button to confirm the
setting.
Acoustic signals
Acoustic signals sound when a malfunction
of the appliance occurs. It is not possible to
deactivate these acoustic signals.
There is also an acoustic signal that sounds
when the programme is completed. By
default this acoustic signal is activated but it
is possible to deactivate it.
How to deactivate the acoustic signal for
the end of programme
The appliance must be in programme
selection mode.
1. To enter the user mode, press and hold
simultaneously
the indicators
start to flash and the display is blank.
2. Press
• The indicators
go off.
go
• The indicator
• The display shows the current setting:
= Acoustic signal on.
3. Press
= Acoustic signal off.
4. Press the on/off button to confirm the
setting.
4. Open the water tap.
5. Start a programme to remove any
processing residuals that can still be
inside the appliance. Do not use
detergent and do not load the baskets.
and
, ,
,
continues to flash.
to change the setting.
13
until
and
and