Option 3 : Using Video (Cvbs) Socket - Philips ShowView DVDR612 User Manual

Option 3 : Using Video
(CVBS) socket
Antenna or
Satellite/Cable TV signal
5
This cable, usually featuring yellow cinch
plugs, is used for transmitting the
Composite Video signal (FBAS, CVBS). In
this method of transmission, the colour
signal and the brightness signal are
transmitted on the same cable.
Have the following cables ready:
1) Antenna cable
2) Video (CVBS) cable (yellow, not supplied)
3) Audio cables (red/white, not supplied)
1
Turn off your TV and remove the antenna
cable from your TV (or Satellite Receiver/
Cable Box). Insert it into the
ANTENNA IN socket at the back of
the DVD recorder.
2
Use the supplied antenna cable to
connect the DVD recorder's TV OUT
socket to the antenna input socket at the
back of your TV set.
3
Use a video (CVBS) cable to connect the
DVD recorder's VIDEO (CVBS) OUT
socket to the Video In socket at the back
of your TV set (or labelled as Video In, AV
In or Composite).
1DVDR6xx_Eng00_13454c
2
1
13
Connecting to TV
TV
S-V ID E O
AU D IO IN
O U T
V ID E O IN
SCART IN
4
3
4
Use an audio cable (red/white) to
connect the DVD recorder's
AUDIO L/R OUT socket to the audio
input socket at the back of your TV set
(or labelled as AV In or Audio In).
5
Connect the power cable from the DVD
recorder's ~ MAINS to the power
supply.
6
Press STANDBY-ON 2 on the DVD
recorder to turn it on.
➜ The message 'IS THE TV ON?'
appears on the display panel.
7
Turn on the TV power. Select the correct
Video In channel at the TV (see page 10).
➜
The first installation menu
{ Language and Country } will appear
on the TV.
8
Proceed to page 21 to continue the first
installation.
9/28/04, 1:25 PM
(cont'd)
13
3139 246 13454