Connecting A Pillow Speaker (Ne593 Models Only) - Samsung NE593 Installation Manual

You can connect a pillow speaker to the TV in the hospital using a jumper cable. The speaker functions as a remote control
and speaker.
1. Connect the pillow speaker jumper cable (cable sold separately) from the television's
pillow speaker jack on the wall behind the television.
Pillow Speaker Jack Specifications
y Output jack: RCA type
y Input jumper pin: 1/8" 3-conductor stereo phone pin.
y Signal specifications: Tip-Audio, Ring-Data/Channel change, Sleeve-Common
Tip Ring
How to Use the Pillow Speaker
y Analog type speaker: The pillow speaker has one key.
– Power On: press the key when the TV is in standby mode.
– Channel Up: press the key when the speaker is on.
– Power Off: press and hold the key for more than 3 seconds when the speaker is on.
– An Analog type speaker always works regardless of the Pillow Speaker Type value set in the Hospital mode
setup menu.
y Digital type speaker: The TV supports the Samsung, Philips, or Zenith code.
– This speaker is only compatible with a specified IR code. You can change the code in the Hospital mode setup menu.
– The TV gives priority to the Samsung remote control over the pillow speaker's wired remote control.
– Option : Channel Menu Display.
Pillow Sound Control
Speaker Selection Menu
TV Speaker
External Speaker
12
English

Connecting a Pillow Speaker (NE593 Models only)

Jumper Cable
Pillow Speaker
Sleeve
VOL +
1
3
2
VOL -
TV Speaker
Sound
No Sound
TV Rear Panel
Port to the
PILLOW SPEAKER
Pillow Speaker
Sound
Sound