Connecting A Pillow Speaker (Nc673 Models Only) - Samsung Series 673 Installation Manual

You can connect a pillow speaker to the TV in the hospital using a jumper cable. The speaker functions as a remote control
and speaker. (Jumper cable not provide)
Pillow Speaker
1. Connect the pillow speaker jumper cable (cable sold separately) from the television's PILLOW SPEAKER Port to the pillow
speaker jack on the wall behind the television.
Pillow Speaker Jack Specifications
y Output jack: RCA type
y Input jumper pin: 1/8" 3-conductor stereo phone pin.
y Signal specifications: Tip-Audio, Ring-Data/Channel change, Sleeve-Common
TIP
How to Use the Pillow Speaker
y Analog type speaker: The pillow speaker has one key.
– Power On: press the key when the TV is in standby mode.
– Channel Up: press the key when the speaker is on.
– Power Off: press and hold the key for more than 3 seconds when the speaker is on.
– An Analog type speaker always works regardless of the Pillow Speaker Type value set in the Hospital mode setup
menu.
y Digital type speaker: The TV supports the Samsung, Philips, or Zenith code.
– This speaker is only compatible with a specified IR code. You can change the code in the Hospital mode setup menu.
– The TV gives priority to the Samsung remote control over the pillow speaker's wired remote control.
– Option : Channel Menu Display.
Pillow Sound Control
Speaker Selection Menu
TV Speaker
External Speaker
[HG673-ZA]Install Guide-X0ENG.indd 7

Connecting a Pillow Speaker (NC673 Models only)

Jumper Cable
Ring Sleeve
TV Speaker
Sound
No Sound
TV Rear Panel
HDMI HDMI
IN 3 IN 3
PILLOW
OUT
Pillow Speaker
Sound
Sound
7
English
2014-03-07 10:20:16