Philips DVDR3370H Owner's Manual page 103

a
Check the display of your DVD recorder.
'PRO': 'Progressive Scan' is on
No display: 'Interlaced' is on. Switch your TV to the corresponding
input jack or select the corresponding connection. You can also
switch the Component video output signal as follows:
Disconnect the recorder's power cord.
1
Hold down N on the DVD Recorder while reconnecting the
2
power cord. 'PRO' (progressive scan) appears on the display.
If you want to switch back, repeat steps 1 and 2 . 'PRO' disappears
3
from the display. The DVD Recorder is switched to 'Interlaced.'
Depending on the audio outputs being used, this menu provides you with a selection of settings.
If you are only using the analog audio outputs (red and white AUDIO L/R OUT , AUDIO L/R
OUT jacks), select ' ' in the '
You can select one of the following settings for devices that are connected to the COAX
OUT or OPTICAL AUDIO OUT jacks:
: Dolby Digital and DTS signals are going out unchanged to the digital output. MPEG-2
multi-channel signals are converted to PCM (Pulse Code Modulation).
Use receivers/amplifiers
: Dolby Digital and MPEG-2 multi-channel signals are converted to PCM (Pulse Code
Modulation).
For receivers/amplifiers
: digital output is off.
For devices
You can select from the following settings for devices connected to the analog outputs ( AUDIO
L/R OUT , AUDIO L/R OUT ).
: For devices that use neither DolbySurround nor TruSurround. Only use this setting
when the DVD Recorder is connected to a stereo TV.
: Dolby Digital and MPEG-2 multi-channel are mixed to a Dolby Surround-compatible
two-channel output signal.
For devices
User preferences
' menu.
.
.
.
.