Philips DVDR 77/00 User Manual page 31

Installing your DVD recorder
7
Select the desired screen format position using B or A . These
settings will only be used if you insert a DVD that contains this
information.
' ' for a 'wide-screen' (cinema format) picture with black bars at
the top and bottom.
' ' for a full-height picture with the sides trimmed.
' ' for a wide-screen TV set (screen edge ratio 16:9)
8
Confirm with OK .
9
Select the country of your residence with B or A .
If your country does not appear, select '
To call up the specific settings for the respective country, you must first install
the country.
0
Confirm with OK .
A
After you connect the aerial (or cable TV, satellite receiver, etc.) to
the DVD recorder, press OK .
The automatic TV channel search starts. '
display.
a
b Select channel 1 on the TV set. Can you see the stored TV channel on the
TV set?
If not, check the cable connection from the aerial (aerial socket) to the
DVD recorder and to the TV set.
b Please have patience.
The DVD recorder searches the entire frequency range in order to find
and save the largest possible number of TV channels.
b If you have not connected an aerial, go through all the basic settings right
to the end and then, if you wish, start the automatic search (see 'Automatic
TV station search').
B
When the automatic TV channel search is complete, '
' will appear on the TV screen.
' ', ' ', '
C
Check if the time in '
À
If required, change the time with the number buttons 0..9 on your
remote control.
Á
Select the next line with A or B .
Â
Check if the displayed settings for '
correct.
Ã
When all information is correct, save by pressing OK .
'.
' will appear on the
', ' ' will then appear on the TV screen.
' is correct.
', ' ' and ' ' are