Advertisement
WARNING! Some manufacturer might place a protective plastic film
on the windscreen of their latest vehicles. The bracket may leave
a mark on these windscreens; therefore check your vehicle's user
manual for information regarding your windscreen.
Mounting to dashboard
• Locate a suitable mounting location and
clear that spot thoroughly.
• Remove the protector foil from the Velcro
tape and attach it to the device.
• Remove the protector foil from the Velcro tape attached to the de-
vice and mount the equipment on the selected and cleaned surface.
• Connect the device and the cigarette lighter socket via the power
cable.
Stealth installation
Because the device at the same time displays the threat and gives
a voice signal in the selected language, it may be installed into hid-
den compartments. There are many places where it can be hidden,
for example, in the glove-box, in the car's center console, into the
compartment of the armrest, or even below the dashboard. After
locating the given spot, follow the steps of the "Mounting to dash-
board" section.
In case of a stealth installation, a GPS receiver is also necessary to
ensure the connection between the GPS Detector and the satellites.
For the best efficiency, the receivers should be placed to the lower
part of the windscreen. If the windscreen is metalized, the receivers
should be installed into the front bumpers.
4
Advertisement
