Clearing A Jam; After Use - ALDI WCHD 14.4-2 User Manual

5401203-Hammerdril_man 16.12.16 14:28 Seite 27
Releasing a jammed bit
1.
2. Check whether the jam is caused by the cordless hammer drill by
3. If you are drilling, please ensure that the control dial (3) is set to
4. If using the screwdriver function, please set the torque ring (2) to a
5. Briefly activate the on/off switch and exert slight pressure on the
6. Take intermittent breaks and remove the drill from the drill hole to
7. Repeat steps 4 and 5 until the blockage is cleared.

After use

1.
2. Set the rotation selector (5) to the center position to prevent it from
3. Push the rechargeable battery release button (11) of the
4. Let the cordless hammer drill cool off completely.
5. If necessary, remove the fitted tool.
If the cordless hammer drill jams, release the on/off switch (7) and
retrieve the drill from the hole.
briefly pressing the on/off switch. In the process, do not direct the
drill toward yourself or other persons or animals.
• If the battery drill does not start, please follow the instructions in
chapter "Troubleshooting", point 1.
• If the battery drill functions perfectly, please follow the next steps
in this chapter.
(hammer drilling) for bricks, concrete or stone. Place the drill
back into the drill hole.
higher torque.
battery drill.
allow the bit to cool down.
Switch the cordless hammer drill off by releasing the On/Off
switch (7).
unintentionally activating.
rechargeable battery (8) and pull the rechargeable battery out.
After use
27