Connecting Other Components - Yamaha CRX-E300 Owner's Manual

To enhance your system, you can connect other components. Refer to the instructions of each component.
Connecting KX-E300 and MDX-E300
<MDX-E300>
System
control cable
(supplied with
ANALOG
OUT
IN D C
L
KX-E300)
R
<KX-E300>
B
IN
L
R
1
Connect Å to Å, and ı to ı (for connecting KX-E300), Ç to Ç and Î to Î (for connecting MDX-E300) using
audio pin cable.
2
Connect the DIGITAL OPTICAL OUT jack of CRX-E300 to the DIGITAL OPTICAL IN jack of MDX-E300.
Take off the covers of the optical cable plug, the DIGITAL OPTICAL OUT jack, and the DIGITAL OPTICAL IN
jack before making digital connections. Be sure to replace the jack's cover when the jack on the rear panel is not being
used, in order to protect from dust.
3
Connect an external component to the AUX jack of CRX-E300.
4
Connect CRX-E300 to MDX-E300 and MDX-E300 to KX-E300 with the system control cables.
The connection using the SYSTEM CONNECTOR jack allows you to control this unit as well as the connected
components of YAMAHA Piano Craft series.
• If your system does not include MDX-E300, connect CRX-E300 and KX-E300 directly.
5
AC OUTLET
Connect the AC power plug of MDX-E300 to the AC outlet of CRX-E300. Then connect the plug of KX-E300 to the
AC outlet of MDX-E300.
• If your system does not include MDX-E300, connect the plug of KX-E300 to the AC outlet of CRX-E300.
Caution
• Never turn CRX-E300 on until all connections between components have been completed.
• Never connect or disconnect the system control cable and/or power cord while the system components are turned on.

Connecting other components

Optical cable (EIA standard)
(commercially available)
SYSTEM DIGITAL
System control cable
CONNECTOR OPTICAL
1 2
IN (supplied with
MDX-E300)
Audio pin cables
A
OUT
SYSTEM
CONNECTOR
GETTING STARTED
As this terminal is used for an
examination in the factory, do not
connect any equipment to this terminal.
2
FM ANT GND – AM ANT SPEAKERS
75Ω UNBAL.
R L
DIGITAL
SUBWOOFER
OPTICAL
OUT OUT
SYSTEM CONNECTOR
6Ω MIN. /SPEAKER
C
CLASS 2 WIRING
IN 4
MD
OUT
D
A 1
IN
TAPE
OUT
B
AUX
3
IN
R L
5
To wall
outlet
<CRX-E300>
7