Pebble pebblewifi Manual page 25

BlinkUp Troubleshooting
•Stuck at "No Wi-Fi settings"?
The Pebble hasn't received any BlinkUp settings - consult the advice above.
•Stuck at "Searching for Wi-Fi network"?
Check that your network name (SSID) is entered correctly. Note that the Pebble will only join
2.4GHz Wi-Fi networks, not 5GHz ones.
•Stuck at "Joining the Wi-Fi network"?
Check that your network password is entered correctly.
•Stuck at "Getting IP address"?
Ensure that DHCP is active on your router and has enough possible IP address for all
devices, including the Pebble. Also check that "MAC address filtering" isn't enabled, or isn't denying
the Pebble access.
•Stuck at "Resolving server name"?
Check the DNS settings on your router. Some early Pebbles may be confused by the "DNS Relay"
mode on some routers; try disabling this mode if need be.
•Stuck at "Connecting to server"?
Check the firewall settings on your router. The Pebble needs to make a TCP connection to port
31314; ensure this is not blocked. Only TCP 31314 needs to be open; UDP 31314 can remain closed.
•Connects to server (green flash), then flashes red, then repeats?
This is usually the symptom of a run-time error in the Pebbles code. Contact www.pebble.com
of your