Pebble pebblewifi Manual page 19

E. Connect Pebble to Power (and turn on at wall)
– Tick legacy button (some phones
F. Only do this step if your first blinkup failed otherwise skip to step H
will require legacy blinkup mode)
G. Press "Clear Wireless Configuration" button &
before 3 second timer runs out - Place Pebble on top of
phone screen. The sensor on underside of pebble must be on phone screen to read signal from phone
H. Wait 10-15 seconds until phone screen stops flashing then watch the lights on Pebble
I. Remove pebble from phone
J. If pebble flashed ORANGE – clearing is successful If the pebble flashed RED and/or GREEN it has not been
successful go back to step D