Table of Contents
Advertisement
Operation
Function menu
Menu Language
When you start using your set for the first time, you must
select the language which will be used for displaying
menus and messages.
A
Press the
MENU button and then use the
button to select the Function menu.
B
Press
the
/ ENTER button and then use the
/
button to select Language.
C
Press
the
/
button to select a language.
( English,
Español or Français
Language
Video
Aspect Ratio
Audio
OSD Timeout
Channel
DPMS
CEC Setup Menu
DCR
Lock
Aspect Ratio
Occasionally, you may want to change the size of the
image on your screen. Your TV comes with several screen
size options, each designed to work best with specific
types of video input. Your cable box/satellite receiver
may have its own set of screen sizes as well. In general,
though, you should view the TV in Normal mode as
much as possible.
Note
If a fixed image is displayed on the screen for a
long time, the image may become permanently
burned on the screen and remain visible.
A
Press the
MENU button and then use the
/
button to select the Function menu.
B
Press
the
/ ENTER button and then use the
/
button to select Aspect Ratio.
C
Press
the
/
button to select
Cinema, Zoom.
EN-17
Haier LED HDTV
OSD Timeout
A
B
C
/
DPMS
)
Press the
A
English
Normal
Long
On
Off
B
Enter
Move
Exit
CEC Setup Menu
Consumer electronic control
other devices using your remote control when those
devices are connected via HDMI.
A
B
CEC function: Turn CEC On of Off. When set to Off, your
TVwill not send or receive any CEC commands.
Device Discovery: Register devices with
CEC will work, perform a device discovery to see if there
16:9, Normal,
are any CEC supported devices connected to your TV.
-38-
Press the
MENU button and then use the
/
button to select the Function menu.
Press
the
/ ENTER button and then use the
/
button to select OSD Timeout.
Press
the
/
button to select Short, Middle
or Long. (Short is for 5 seconds; Middle is for 10
seconds; Long is for 15 seconds)
/ ENTER button to selet On or Off.
I
n PC mode, the
TV
will go into standby mode
automatically if there is no PC input signal present
for
1
minute. The set will turn on and automatically
go into PC mode when the PC input is connected.
With all other sources, the set will go into standby
mode automatically if there is no signal present for
5
minutes.
(CEC)
Press the
TOOLS button and then use the
/
button to select CEC Setup Menu.
Press the
/
button to set.
Note
Only devices that support CEC will be compatible
allows you to control
your
TV. Before
Advertisement
Table of Contents
