Table of Contents
Advertisement
Operation
Note
If skip is set to ON for a channel, pressing the
CH /
buttons will not show the skipped
channel(s).
You can also enter a channel number directly by
entering the channel number using the number pad
on the remote control and then pressing ENTER.
Select the desired
Press the VOL-/+ buttons on the remote
the TV set to adjust the volume level. The range is 0~100.
When the volume buttons are pressed the volume level
is displayed automatically on the TV screen.
Mute
Press the MUTE button on the remote control and
an icon indicating the MUTE function is active will
display on the screen. At this time, the sound of the
TV set is turned off.
If you want to
enable
the sound, press the MUTE
button again or directly press the VOL+ button.
SAP Broadcasts Setup
This TV can receive MTS stereo programs and SAP
(Secondary Audio Program) that accompanies the stereo
program, if the station transmits an additional sound
signal as well as the original one.
When the MTS button on the remote control
the TV
will
only receive the signal
transmits the proper signals.
Mono sound is automatically received if the broadcast is
only in Mono, even
if
Stereo or SAP has been selected.
Select Mono if you want to listen to mono sound during
stereo/SAP broadcasting. Stereo or SAP can be received
in
an analog channel.
Use
the
MTS button to select your desired MTS
mode in
an
analog
signal.
Each time you press the MTS button, Mono, Stereo
or SAP appear. If other languages are available
in the digital signal, select them with the MTS
button.
Press the EXIT button to save and return to TV
EN-13
Haier LED HDTV
volume level
or
the
side
of
is
pressed,
if
the TV station
viewing.
Channel menu
This TV set has two methods to set the channels:
Channel Scan and Channel Skip.
In this section,
using
the remote control to set the
channels is explained. You can also use the buttons
on the TV to set the channels.
Note
The Channel Menu is only accessible while the
input source is set to TV.
Channel Scan
Press the MENU button and then use the
/
button to select the TV menu.
Press the
/ ENTER button to select Antenna.
Press the
/
button to select Air or Cable mode.
Press the
/
button to select Channel Scan.
Press the
/ ENTER button to start searching.
To cancel searching, press the EXIT button.
Note
When Air is selected, the TV will detect antenna
signals and will search for antenna TV (NTSC and
ATSC) channels available in your local area.
When Cable is selected, the TV will detect cable
company supplied signals and will search for cable
TV (NTSC, QAM modulated) channels available in
your Area.
-34-
Advertisement
Table of Contents
