Table of Contents
Advertisement
Universal Remote Control
Universal Remote Control
Setting UpYour Remote Control
After it has been set up properly, your remote control
can operate in
four
di erent modes: TV, DVD, VCR or
CABLE.
Note
The remote control might not be compatible
with all DVD Players, VCRs and Cable boxes.
Control Operation
Program the remote control to work with your
device.
Change the device mode by pressing the TV, DVD,
CABLE or VCR key. When the device is set, the related
device LED will turn on for 1 second and then turn
o .
Aim the remote at the device.
Use the other remote control buttons to operate the
device. The device LED will blink if you press any key
(if the key has a function in the current mode). If the
key has no function, then the LED will not blink.
Manually Programming the
Check the code no. from the code list.
Choose the device you want to program.
While pressing and holding the ENTER key, press
the INPUT key, and the device LED will be ON.
about
3 seconds, and the LED will blink, indicating
that the remote control is ready for programming,
then release both keys.
The LED
will blink once when you enter a digit key,
indicating the digit key is programmed. If 3 digits are
programmed successfully, the device LED will turn
ON for about 3 seconds and then blink twice per
second.
You can now:
A)
Try to operate the device by using
B)
If the device powers on, press the
save the current
3-digit code to memory
the manual programming mode.
C)
Return to step 3
to
reprogram the control.
EN-36
Haier LED HDTV
Remote
Control
After
the power key.
ENTER key to
and exit
-57-
If your input is incorrect, the LED will blink 6 times
in 3 seconds. And then keep blinking. You can now
return to step 3 and reprogram the device. You must
enter the 3-digit brand code corresponding to your
device within 30 seconds. If time
other than Power
or digits are
turn o and the manual programming process will
exit.
Manual scan mode
With manual scan and program, the remote control
tests all the codes available in the codeset database and
assigns the correct one for the selected device. Although
this method is more time consuming, it saves you the
trouble of looking up the brand codes necessary for
manual programming.
To manually-scan and program the remote control:
Turn OFF the device
that you wish to
VCR, DVD or cable box equipment).
Choose the device you want to program.
While pressing and holding the ENTER key, press
the INPUT key,
and
the
device LED will be ON.
remain on for about
3 seconds and then
blink, indicating that the
programming, then release both keys.
Press and release the CH / key. it will emit the
next or the previous POWER key code. The LED
blink rapidly (10 times per
the remote control is in manual scan mode.
Press the CH / key repeatedly until the device
switches ON (CH
key conducts a upward search
while the CH
key conducts a downward search in
the code set database). When the device turns ON,
press and release the ENTER key to program the
remote control with the new code, saving
to memory.
After saving the new code, press the POWER key.
If the device responds, no further programming is
required. If the device does not respond, repeat
step 3 through 5. And searching will start from the
current code that is set.
To exit without programming, press any other key. The
code will not be saved to memory.
After searching the entire data base, this mode will
automatically exit and the LED will blink 3 times. The
code will not be saved to memory.
Automatic Scan Programming the
runs out
or any key
pressed, the LED will
program. (TV,
It will
the
LED will
remote
control is ready for
will
second), indicating that
the code
Remote
Advertisement
Table of Contents
