Tank Filling And Water Treatment - First Degree FLUID E720 Owner's Manual

Tank filling and water treatment

Note: A large bucket is required for filling (Not included)
In areas where tap water quality is known to be
poor, FDF recommends the use of distilled water.
Open the rear upper yellow tank plug and insert hose into
tank (rotating the impeller slightly may be necessary to al-
low the hose to pass), move the tank adjuster handle to
level 20 and begin filling. Do not fill the tank higher than
the level indicator on the front of the clear shell. A prop-
erly filled tank holds approximately 8liters of water.
Warning:
Do not under any circumstances put
fingers into the tank. Use the end of the hose to
move the impeller should the need arise.
Water Treatment Procedures:
Blue Dye
1. Add Chlorine tablet.
2. Wait a minimum of 72 hours.
Then add very small amount of blue
dye and check for desired color. Im-
portant! Do not add blue dye for at
least 72 hours following Chlorine
treatment. The blue dye adds visual
Note: The blue
appeal as well as cutting down the
dye is extremely
amount of light affecting the tank water,
concentrated and
thus extending the amount of time be-
will readily stain
tween water treatments.
carpet or clothing.
Caution
:
Use a drop cloth when filling or
adding blue dye
8
Filling hose
and funnel
Yellow
tank plug