First Degree FLUID E720 Owner's Manual page 14

Tank Belt Adjustment
Rubber belt cover
Step 1
Step 3
14
Step 1: Remove large metal in-
spection plate as shown above
right.
Step 2: Using a long tool, push out
the rear end cap as pictured above
right. This will give you access to
the tank tensioning bolt (shown bot-
tom right).
Step 3: Loosen both the rear and
front tank bolts slightly as shown
left. Remove front rubber belt
cover.
Step 4: Using a 6mm Allen key,
tighten the belt using the tank ten-
sioning bolt until the belt no longer
slips during hard rowing.
Note: Do not over tighten tank
bolts.
Step 2
End Cap
Tip: Twist the belt by hand to gauge tightness. Cor-
rect tension should be obtained when no longer able
to twist more than 60 degrees.
Tank tensioning bolt
Step 4