Chapter 2 Settings; Menu - Buffalo BS-XP20 Series User Manual

Chapter 2 Settings

Refer to the "Open Settings" section in chapter 1 to access Settings.

Menu

System Information
Basic
System
System IP Settings
VLAN
MAC Addresses
Port Settings
System Security
Advanced
QoS
Security
Port Trunking
Traffic Control
Mirroring
IGMP
Loop Prevention
Management
Update Firmware
Back Up and Restore
Reboot
Initialize
Statistics
Network Diagnostics
Cable Diagnostics
VLAN Settings
VLAN Ports
Static MAC Filtering
Status
Speed/Mode Settings
Administration
Account
QoS Settings
QoS Mapping
VoIP Auto Priority
Auto DoS Attack
Prevention
Status
IGMP Settings
IGMP Querier
IGMP Router Port
Displays the switch's information.
Configure the switch's name, location, and contact.
Configure the switch's IPv4 address, subnet mask, and
default gateway.
Confirm VLAN status and create new VLAN. This switch's IP
address can also be configured on this page.
Configure PVID (Port VLAN ID).
Configure static MAC address-based filtering.
Displays port status.
Configure transmission rate and flow control for each port.
Configure administration username and password.
Configure QoS priority.
Configure QoS mapping for each priority.
Configure priority for SIP, H.323, SCCP.
Configure to drop specified packets.
Configure port trunking.
Configure traffic storm control.
Configure to monitoring traffic.
Displays IGMP status.
Configure IGMP snooping.
Configure IGMP querier.
Specify ports to connect to multicast routers.
Configure loop prevention settings.
Update firmware from a local file.
Save settings to a file or restore settings from a file.
Reboot the switch.
Initialize the switch.
Displays the switch's statistics.
Execute communication test to the specified IP address.
Confirm abnormalities of each Ethernet cable connected
to the switch.
16