Energy Saving - Gaggia PRESTIGE Operating Instructions Manual

• (Fig.27) - Close the knob (3) and remove the container.
• Fill 1/3 of the container you wish to use to prepare the cap-
puccino with cold milk.
Use cold milk to get a better result.
• (Fig.28) - Immerse the steam wand in the milk and open
the knob (3) by turning it counter-clockwise. Turn the milk
container with slow upward movements so that it warms
up evenly.
• (Fig.29) - At the end, close the knob (3) and take the cup
with frothed milk.
• (Fig.25) - Press the steam button (20) again.
• Prime the circuit as described in Section 4.5 to make the
machine ready for use.
Never brew coff ee when the (
pressed or when the indicator light (21) is on,
because this means that the steam function is on and
the temperature of the boiler is too high.
Wait for the coff ee ready condition to be active (19 indi-
cator light on) before brewing coff ee.
Note: the machine is ready when the "machine
ready" indicator light (19) is permanently on.
Important note: if it is not possible to brew a
cappuccino as described, prime the circuit as
explained in Section 4.5 and then repeat the steps.
The same procedure can be performed to heat
other beverages.
• After this operation, clean the steam wand with a wet
cloth.

9 ENERGY SAVING

The machine is equipped with an auto power-off function for
energy saving.
To restart the machine, press the ON/OFF button (16); the "ma-
chine on" indicator light (17) turns on.
Wait until the "machine ready" indicator light (19) turns on.
• 26 •
10 CLEANING
Maintenance and cleaning can only be carried out when the
machine is cold and disconnected from the electric network.
• Do not immerse the machine in water or place any of its
parts in a dishwasher.
• Do not use spirit, solvents and/or aggressive chemical
agents.
• We recommend cleaning the water tank and refi lling it
with fresh water daily.
• (Fig.31-33) - Every day, after heating milk, remove the
external part of the Pannarello and wash it with fresh
drinking water.
• (Fig.31-32-33) - Clean the steam wand weekly. In order
to do this, perform the following operations:
- Remove the external part of the Pannarello (for standard
cleaning);
) button is
- Remove the upper part of the Pannarello from the steam
wand;
- Wash the upper part of the Pannarello with fresh drinking
water;
- Wash the steam wand with a wet cloth and remove any
milk residue;
- Reposition the upper part in the steam wand (make sure
it is completely inserted);
- Reassemble the external part of the Pannarello.
• (Fig.34) - Empty and clean the drip tray every day.
• Use a soft, dampened cloth to clean the appliance.
• (Fig.21) - Perform the following operations to clean the
pressurized fi lter holder:
- (Fig.11) - Remove the fi lter and wash it thoroughly with
hot water.
- Remove the adapter (if fi tted), and wash it thoroughly
with hot water.
- Wash the internal part of the pressurized fi lter holder.
• Do not dry the machine and/or its parts using a microwave
and/or standard oven.