Dodge Charger SRT 392 2017 Owner's Manual page 334

332 STARTING AND OPERATING
• Launch Control is intended to be used on dry, paved
road surfaces only. Use on slippery or loose surfaces
may cause damage to vehicle components and is not
recommended.
Launch Control is available when the following proce-
dure is followed:
1. Push the LAUNCH button on the center stack switch
bank.
NOTE: Pushing the SRT button on the center stack or
pressing the "Apps" button on the touchscreen are two
other options to access launch control features. Please refer
to "Uconnect Settings" in "Understanding Your Instrument
Panel" for further information.
2. Push the "Launch RPM Set-Up" button on the touch-
screen. This screen will allow you to adjust your launch
RPM's for optimum launch/traction.
3. Push the "Activate Launch Mode" button on the touch-
screen.
4. Make sure the vehicle is not moving.
5. Make sure the steering wheel is pointing straight.
6. Hold the brake and make sure the vehicle is in "DRIVE"
or "AutoStick" position.
7. While holding the brake, rapidly apply the accelerator
pedal to wide open throttle. The engine speed will hold
at the RPM that was set in the "Launch RPM Set-up"
screen.
NOTE: Messages will appear in the instrument cluster to
inform the driver if one or more of the above conditions
have not been met.
8. When conditions 4 through 7 have been met, the instru-
ment cluster display will read "Launch Ready Release
Brake".
9. Keep the vehicle pointed straight.
Launch control will be active until the vehicle reaches
62 mph (100 km/h), at which point the ESC system will
return to its current ESC mode.
Launch control will abort before launch completion, dis-
play "Launch Aborted" in the cluster under any the
following conditions:
• The accelerator pedal is released during launch. ESC
system continues in ESC Full ON.
• The ESC system detects that the vehicle is no longer
moving in a straight line.