Tuner Operations; Tuning To Radio Stations; Presetting Radio Stations; Using The Plug And Play - Philips HTS5500C/55 User Manual

Tuner Operations

IMPORTANT!
Make sure the FM and MW
antennas are connected.

Tuning to radio stations

1
Press TUNER on the remote (or press
SOURCE control at the front panel) to
select "TUNER/FM" or "TUNER/MW."
2
Press 3 / 4 briefly on the remote.
➜
The display panel will show
"SEARCH >" until a radio station with
sufficient signal strength is found.
3
2
Repeat step if necessary until you find
the desired radio station.
4
To tune to a weak station, press 1 / 2
briefly and repeatedly until an optimal
reception is found.
G
If the FM station reception is weak, you
can switch the FM mode from stereo to
mono. Press SURR button will toggle
through:
DOLBY PL II FM ST (stereo)
™ DOLBY PL II FM MONO
™ STEREO FM MONO
™ STEREO FM ST
42
001-051-hts5500-55-Eng3

Presetting radio stations

You can store up to 20 FM and 10 MW
preset radio stations in the memory.
Helpful Hints:
– The system will exit presetting mode if no
button is pressed within 20 seconds.
– If no valid frequency is detected during
Plug and Play,"CHK ANTENNA" appears.

Using the Plug and Play

Plug and Play allows you to store all
available radio stations automatically.
AUTO PRESET PRESS PLAY
1
For first time setup, press SOURCE
on front panel to select TUNER mode.
➜ "AUTO PRESET PRESS PLAY"
appears.
2
Press 2; on the top panel or 2 on the
remote control to enter into auto install
mode.
➜
The system will start searching from
FM band and followed by MW band.
All the available radio stations with strong
signal strength will be stored
automatically.
➜
Once complete, the last tuned radio
station will play.
42
SOURCE PLAY PAUSE
1 2
3139 246 14793
05/04/05, 4:18 PM