Samsung HC460 Installation Manual page 22

¦ Setting Auto Initialize
When you clone settings from one TV to another, you clone both the guest side menu and hotel side menu settings: Picture,
Sound, Input, Channel, Setup, and Hotel Setup. This lets you set nearly all of the menu values on your hospitality TVs to
the same, standard settings. If you allow guests access to the guest side menus, for example the Picture menu, they can
change the settings in those menus so they are no longer standard. If you set the Setting Auto Initialize function to on the TV
automatically restores (initializes) any guest-side menu values to the cloned, standard values when the TV is turned off and
then turned on again. Note that Setting Auto Initialize works on cloned guest side menu values only. Settings which have not
been cloned are ignored.
The table below lists the settings that are restored to their cloned values when you set the Setting Auto Initialize function to
on.
Menu
Picture Mode
Backlight
Contrast
Brightness
Sharpness
Color
Tint (G/R)
Picture Size
Picture Size
Position
PIP
Advanced Settings
Dynamic Contrast
Black Tone
Picture Menu
Flesh Tone
RGB Only Mode
Color Space
White Balance
Gamma
Motion Lighting
Picture Option
Color Tone
Digital Clean View
MPEG Noise Filter
HDMI Black Level
Film Mode
Picture Off
Reset Picture
22
English
[HC460-ZA]Install-Guide-X0ENG.indd 22
Menu Item
Sound Menu
System Menu
Menu Menu Item
Sound Mode
Sound Effect
DTS TruSurround
DTS TruDialog
Equalizer
Speaker Settings
Speaker Select
Auto Volume
Reset Sound
System
Menu Language
Time
Clock
Sleep Timer
Wake-up Timer
Eco Solution
Energy Saving
Eco Sensor
No Signal Power Off
Auto Power Off
Auto Protection Time
Change PIN
General
Game Mode
Boot Logo
Anynet+ (HDMI-CEC)
Anynet+ (HDMI-CEC)
Auto Turn Off
DivX® Video On Demand
2014-06-05 10:39:09