Child Lock Function; Care And Cleaning; Outside Surfaces - Hyundai H-MW1220 Instruction Manual

The following steps are needed if we are going to set a cooking program which involves jet defrost, microwave, and grill.
Press « . .» program and set the defrost time needed.
Touch memory pad-«
Press « », enter cooking time and power level you need.
Touch memory pad-«
Press « » and enter the cooking time you need.
Touch « » pad to start cooking. After the end of 1st and 2nd cooking stage the oven will beep once.

Child lock function

Lock: In waiting state, press "
"LOCK".
Lock quitting: In locked state, press "
Note: You cannot operate the oven while the child lock is set.

Care and cleaning

Always turn timer to «0» position then unplug oven and be sure oven is cool before cleaning.
To maintain the appearance of your oven, never use abrasive cleaning agents (such as cleaning powders, scouring pads or steel wool pads), spray. Also,
never use commercial oven cleaners on any part or your microwave oven.
If the microwave is very dirty, otherwise, use a damp cloth.

Outside surfaces

Cover
Clean the outside of the oven with a glass-cleaning agent, a liquid cleaner or mild detergent and water. Use a damp cloth or sponge, rinse and dry.
Plastic
Use a liquid or glass-cleaning agent and a sponge or cloth. To prevent scratching the plastic surface, do not use paper toweling.
Door and control panel
Clean with a damp cloth or sponge. Use dishwashing detergent and water or liquid glass-cleaning agent to remove soil. Rinse with a damp cloth and dry
with a soft cloth to prevent scratching the plastic outer door panel. Some paper towels can scratch the plastic door panel, therefore, use a soft cloth to dry
the door. When cleaning the control panel, keep oven door open to prevent oven from accidentally turning on.
Power cord
Be sure oven is unplugged. Wipe cord with a damp sudsy cloth, rinse and dry thoroughly before plugging cord back into outlet.
.»
.»
" for 3 seconds, there will be a long "beep" denoting entering into the children-lock state and display will indicate
" for 3 seconds, there will be a long "beep", and "LOCK" will disappear.
9