Troubleshooting - Yamaha R-N602 Owner's Manual

Troubleshooting
Problem
Cause Remedy
See
page
Only the speaker on
Incorrect cable connections. Connect the cables properly. If the problem persists,
ll
one side can be
the cables may be defective.
heard.
Incorrect setting for the speaker balance. Set the BALANCE control to the appropriate
22
position.
There is a lack of bass The
+
and- wires are connected in Connect the speaker wires to the correct
+
and -
12
and no ambience.
reverse at the amplifier or the speakers. phase.
A "humming" sound Incorrect cable connections. Connect the audio plugs firmly. If the problem
11
can be heard. persists, the cables may be defective.
No connection from the turntable to the Make the GND connection between the turntable and
11
GND terminal. this unit.
The volume level is
The record is being played on a turntable The turntable should be connected to this unit through
low while playing a with an MC cartridge. the MC head amplifier. -
record.
The sound is
The power of this unit is turned off, or this Tum on the power of this unit.
degraded when
unit is set to standby mode.
listening with the
headphones
-
connected to the CD
player or the tape
deck connected to
this unit.
The sound level is
The loudness control function is Turn down the volume, set the LOUDNESS control
low.
operating.
to the FLAT position, and then adjust the volume 22
again.
51
En