Tuner Operations; Tuning To Radio Stations; Presetting Radio Stations; Using The Plug And Play - Philips HTS3300/51 User Manual

Tuner Operations

IMPORTANT!
Make sure the FM and MW
antennas are connected.

Tuning to radio stations

1
Press TUNER on the remote (or press
SOURCE control at the front panel) to
select "FM" or "MW".
2
Press 3 / 4 briefly on the remote.
➜
The display panel will show "SEARCH"
until a radio station with sufficient signal
strength is found.
3
2
Repeat step if necessary until you find
the desired radio station.
4
To tune to a weak station, press 1 / 2
briefly and repeatedly until an optimal
reception is found.
36
001-045-hts3300-01-Eng3

Presetting radio stations

You can store up to 40 FM and 20 MW
preset radio stations in the memory.
Helpful Hints:
– The system will exit presetting mode if no
button is pressed within 20 seconds.
– If no valid frequency is detected during
Plug and Play,"PLEASE CHECK FM/MW
ANTENNA" appears.

Using the Plug and Play

Plug and Play allows you to store all
available radio stations automatically.
1
For first time setup, press TUNER.
➜
appears.
2
Press PLAY B until "START ..." appears
on the display panel.
➜
FM band and followed by MW band.
All the available radio stations with strong
signal strength will be stored
automatically.
➜
station will play.
36
DVD system's
2 START..
AUTO INSTALL..
1
"AUTO INSTALL PRESS PLAY"
The system will start searching from
Once complete, the last tuned radio
12/9/05, 11:30 AM
display panel
3139 115 2xxx1