Advertisement
INSTALLATION INSTRUCTIONS
TRIM INSTALLATION
- Place the shower plate onto the all thread.
- Screw the handle bell and flange onto the all thread, make sure that
both parts are flushed firmly against the plate. Mark the position and
remove the handle bell and flange and cut off the excess thread.
Reinsert the handle bell and flange onto the all thread.
- Insert the handle onto the stem. Measure the excess between the handle
bell and the handle. Take off the handle and cut the excess stem.
- Reinsert the handle onto the stem. Using the Allen key provided, tighten the
handle set screw firmly.
- Place the Trim Plate Grommet onto the designated hole for the
Diverter Rod on the Trim Plate.
- Screw the Diverter Knob onto the Diverter Rod.
H H
H H
DIVERTER CARTRIDGE- TE050
PM-460 - DIVERTER SLEEVE
ILLUSTRATION C
HOT
WARMER
C C
C C
WARM
COLD
PM-280 - SERVICE VALVE (OPTIONAL)
FILTER SCREEN - TE012
VALVE CARTRIDGE - TE010
DIVERTER KNOB-P0258
PLATE GROMMET- PM-465
HANDLE FLANGE
MECHANICAL STOP- TE013
LIMIT STOP- TE014
PM-010 - STEM
TEFLON WASHER
PM-009 - LOCK PLATE
1434DD _ _
HANDLE BELL
HANDLE
Trim Plate
All Thread
Stem
Lock Nut
Lock Plate
Diverter Knob
Plate Grommet
Diverter Rod
PM-012 - LOCK NUT
PM-011 - ALL THREAD
PAGE 03
Advertisement
