Advertisement
Dual reflector
③ 360° rotary focusing ring
Technical Parameters
ANSI/PLATO FL1
Output
Runtime
Spotlight
Floodlight
Distance
Spotlight
Floodlight
Intensity
Impact Resistance
Waterproof
Accessories
Notice: The above-mentioned parameters (lab-tested by using Fenix 3.6V/3500mAh 18650
rechargeable Li-ion battery) may vary between flashlights, batteries and environment.
*Due to the dual overheat protection; the runtime of Turbo is estimated.
Fenix FD30 Flashlight
1
Functional switch
Turbo
High
900
350
Lumens
Lumens
2h*
4h30min
200m
117m
67m
43m
10,000cd
3,400cd
1,100cd
460cd
Lanyard, holster, spare O-ring, spare rubber switch boot, body clip
② Tactical switch
④ 18650*1/CR123A*2
General Mode
Med
Low
150
50
Lumens
Lumens
40h
11h
30min
77m
44m
28m
16m
1,500cd
500cd
200cd
65cd
1m
IP68, underwater 2m
Close
Open
Strobe
Eco
8
900
Lumens
Lumens
170h
/
17m
/
8m
/
70cd
/
15cd
/
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Fenix FD30
Summary of Contents for Fenix FD30
- Page 1 Accessories Lanyard, holster, spare O-ring, spare rubber switch boot, body clip Notice: The above-mentioned parameters (lab-tested by using Fenix 3.6V/3500mAh 18650 rechargeable Li-ion battery) may vary between flashlights, batteries and environment. *Due to the dual overheat protection; the runtime of Turbo is estimated.
- Page 2 Uses Cree XP-L HI LED with a lifespan of 50,000 hours Powered by one 18650 rechargeable Li-ion battery or two CR123A batteries 140.5mm Length x 23mm Body Diameter x 25.4mm Head Diameter 96 grams (excluding battery) Dual reflector optical system ...
-
Page 3: Battery Replacement
Disassembling the sealed head can cause damage to the light and will void the warranty. Fenix recommends using excellent quality battery. If the light will not be used for an extended period, remove the battery, or the light could be damaged by electrolyte leakage... - Page 4 Continuous usage at Turbo brightness level in hot or poor heat dissipation environments may cause activation of overheat protection, or light beam trembling. To maintain normal usage, lower brightness level to cool down the flashlight. Long-term use can result in O-ring wear. To maintain a proper watertight seal, replace the ring with an approved spare．...
Need help?
Do you have a question about the FD30 and is the answer not in the manual?
Questions and answers